Borate rods   Cobra™ Rods are a way to spot treat decay prone areas such as log ends that are already coated with a finish.

Once inserted into damp or wet wood the borate / copper complex in Cobra Rods dissolves spreading the active ingredients into areas surrounding the rod. This eliminates active decay fungi and helps prevent rot for 8 to 10 years.

Cobra Rods are available in two different sizes. A fitting drill bit is used for installation. The installation holes may be plugged with the accompanying plastic plugs or Energy Seal.

A typical 15-20 cm round log end will require one long or two shorter Cobra Rods inserted.

Cobra™ Rods are a trademark of Genics Inc., Spruce Grove, Alberta Canada

Use a fitting drill bit to drill hole.	Drill hole to a depth of at least 10 cm.	Clean out the hole and insert the Cobra Rod.	Insert the plastic plug into the hole.
Using a screw driver twist the plug clockwise.	Make sure the top of the plug sets about 0.5 cm below the surface of the wood.	Fill the hole with appropriately colored Energy Seal.	Smooth with tool or finger. After a few hours the Energy Seal may be stained to match the surrounding area.